Standard probe Type «D» for hardness tester TKM‑359CE - Mashproject LLC

Standard probe Type «D» for hardness tester TKM‑359CE

Price: on request

Add to cart
Get offer
Manufacturer: NPP Mashproject LLC
Garanty: 1 year
Description
Exploitation
Technical specifications
Delivery set
Documents

Standard probe Type «D» is included in the Basic delivery set of the Leeb Hardness tester TKM‑359CE.

The Probe Type «D» is used for hardness testing:

  • All basic types of metals and alloys without additional calibrations (structural, tool, corrosion-proof, heat-proof, non-corrosive steels and alloys as well as alloys of nonferrous metals, castiron, aluminium, bronze, brass);
  • Items with surface hardening and high frequency current hardening;
  • Items of complicated configuration;
  • Heavy and big items with rough surface.

Advantages of Leeb probe

  • Hardness measurement in hard-to-reach areas.
  • The spatial position of the probe does not affect the measurement result.
  • The robust housing is not subject to mechanical stress.
  • Long service life.

Probes characteristics

Photo Probe Type Weight/thickness/
surface roughness
of the article
under check

Length/
Diameter

Application
Динамический датчик “D”/“E” для твердомера ТКМ-359 «D» 3 kg/6 mm/Ra 3,2 138/21 mm Solving of main hardness testing tasks with surface roughness less than 3.2 Ra
«E» 3 kg/6 mm/Ra 3,2 138/21 mm
Probe with polycrystalline indenter made of cubic boron nitride to test materials with high hardness
Динамический датчик тип “G” для твердомера ТКМ-359 «G» 6 kg/55 mm/Ra 7,6 200/29 mm Control of items with high structural heterogeneity (cast iron, bronze) and surface roughness Ra from 3.2 to 7.6

ATTENTION! If you buy only probe Type «D», the Hardness tester TKM‑359CE should be sent to the retrofit and alignment.

Additional equipment